Specifications

clear ap boot-configuration
Chapter 12
AP Commands
274
Defaults None.
Access Enabled.
Usage When the static IP configuration is cleared for a UNIVERGE WL Access
Points, and on the UNIVERGE WL Access Points is rebooted, it uses the standard
boot process.
Examples The following command clears the static IP address configuration for
UNIVERGE WL Access Points 1.
PROPMT# clear ap 1 boot-configuration
This will clear specified AP devices. Would you like to continue? (y/n) [n]y
success: change accepted.
See Also
l set ap boot-configuration ip on page 284
l set ap boot-configuration switch on page 285
l set ap boot-configuration vlan on page 287
l show ap boot-configuration on page 401