Specifications

clear ap boot-configuration
Chapter 12
AP Commands
273
Access Enabled
Usage When you clear a radio, UNIVERGE WL Control System performs the
following actions:
l Clears the transmit power, channel, and external antenna setting from the
radio.
l Removes the radio from its radio profile and places the radio in the default
radio profile.
Examples The following command disables and resets radio 2 on the AP 3:
PROPMT# clear ap 3 radio 2
See Also
l set ap radio mode on page 295
l set ap radio radio-profile on page 296
clear ap boot-configuration
Removes the static IP address configuration for a UNIVERGE WL Access Points.
Syntax clear ap boot-configuration ap-number
mode disable Operational state of the radio.
radio-profile None. You must add the
radios to a radio profile.
802.11 settings
tx-power Highest setting allowed for
the country of operation or
highest setting supported on
the hardware, whichever is
lower.
Transmit power of a radio, in decibels
referred to 1 milliwatt (dBm)
ap ap-number Index value that identifies the UNIVERGE WL Access
Points on the UNIVERGE WL Controller.
Table 30. Radio-Specific Parameters
Parameter Default Value Description