Specifications

set network-domain mode seed domain-name
Chapter 11
Network Domain Commands
263
set network-domain mode seed
domain-name
Creates a Network Domain by setting the current UNIVERGE WL Controller as a
seed device and naming the Network Domain.
Syntax set network-domain mode seed domain-name net-domain-name
Defaults None.
Access Enabled.
Usage Before you use this command, the current UNIVERGE WL Controller
must have its IP address set with the set system ip-address command. After you
enter this command, Network Domain traffic is sent and received from the
specified IP address.
You can configure multiple UNIVERGE WL Controllers as Network Domain
seeds. If you do this, you must identify them as peers by using the set network
domain peer command.
Examples The following command creates a Network Domain named California
with the current UNIVERGE WL Controller as a seed:
PROMPT# set network-domain mode seed domain-name California
success: change accepted.
See Also
l clear network-domain on page 258
l show network-domain on page 263
show network-domain
Displays the status of Network Domain seeds and members.
net-domain-name Name of the Network Domain. Specify between 1 and
16 characters with no spaces.