Specifications

set network-domain peer
Chapter 11
Network Domain Commands
262
success: change accepted.
See Also
l clear network-domain on page 258
l show network-domain on page 263
set network-domain peer
On a Network Domain seed, configures one or more UNIVERGE WL Controllers
as redundant Network Domain seeds. The seeds in a Network Domain share
information about the VLANs configured on the member devices, so that all the
Network Domain seeds have the same database of VLAN information.
Syntax set network-domain peer ip-addr
Defaults None.
Access Enabled.
Usage This command must be entered on a UNIVERGE WL Controller
configured as a Network Domain seed.
Examples The following command sets the UNIVERGE WL Controller with IP
address 192.168.9.254 as a peer of this Network Domain seed:
PROMPT# set network-domain peer 192.168.9.254
success: change accepted.
See Also
l clear network-domain on page 258
l show network-domain on page 263
ip-addr IP address of the Network Domain seed to specify as a peer,
in dotted decimal notation.