Specifications

clear network-domain peer
Chapter 11
Network Domain Commands
259
Defaults None.
Access Enabled.
Usage This command has no effect if the UNIVERGE WL Controller is not
configured as part of a Network Domain.
Examples The following command clears the Network Domain member
configuration from the UNIVERGE WL Controller:
Controller# clear network-domain mode member
success: change accepted.
The following command clears the Network Domain seed configuration from the
UNIVERGE WL Controller:
Controller# clear network-domain mode seed
success: change accepted.
See Also
l set network-domain mode member seed-ip on page 261
l set network-domain mode seed domain-name on page 263
clear network-domain peer
Removes the configuration of a Network Domain peer from a UNIVERGE WL
Controller configured as a Network Domain seed.
Syntax clear network-domain peer {ip-addr | all}
Defaults None.
Access Enabled.
Usage This command has no effect if the UNIVERGE WL Controller is not
configured as a Network Domain seed.
ip-addr IP address of the Network Domain peer in dotted decimal
notation.
all Clears the Network Domain peer configuration for all peers
from the UNIVERGE WL Controller.