Specifications

clear network-domain
Chapter 11
Network Domain Commands
258
clear network-domain
Clears all Network Domain configuration and information from a UNIVERGE
WL Controller, regardless of whether the UNIVERGE WL Controller is a seed or
a member of a Network Domain.
Syntax clear network-domain
Defaults None.
Access Enabled.
Usage This command has no effect if the UNIVERGE WL Controller is not
configured as part of a Network Domain.
Examples To clear a Network Domain from a UNIVERGE WL Controller within
the domain, type the following command:
Controller# clear network-domain
This will clear all network-domain configuration. Would you like to continue?
(y/n) [n] y
success: change accepted.
See Also
l set network-domain mode member seed-ip on page 261
l set network-domain peer on page 262
l set network-domain mode seed domain-name on page 263
clear network-domain mode
Removes the Network Domain seed or member configuration from the
UNIVERGE WL Controller.
Syntax clear network-domain mode {seed | member}
seed Clears the Network Domain seed configuration from the
UNIVERGE WL Controller.
member Clears the Network Domain member configuration from the
UNIVERGE WL Controller.