Specifications

set mobility-domain mode seed domain-name

Chapter 10

Mobility Domain Commands

253

mode is: member

seed IP is: 192.168.1.8

See Also

l clear mobility-domain on page 250

l show mobility-domain config on page 254

set mobility-domain mode seed

domain-name

Creates a Mobility Domain by setting the current UNIVERGE WL Controller as

the seed device and naming the Mobility Domain.

Syntax

set mobility-domain mode seed domain-name mob-domain-name

Defaults

None.

Access

Enabled.

Usage

Before you use this command, the current UNIVERGE WL Controller

must have an IP address set with the set system ip-address command. After you

enter this command, all Mobility Domain traffic is sent and received from the

specified IP address.

You must explicitly configure only one UNIVERGE WL Controller per domain

as the seed. All other UNIVERGE WL Controllers in the domain receive their

Mobility Domain information from the seed.

Examples

The following command creates a Mobility Domain named Tokyo

with the current UNIVERGE WL Controller as the seed:

PROMPT# set mobility-domain mode seed domain-name Tokyo

mode is: seed

domain name is: Tokyo