Specifications

set mobility-domain member
Chapter 10
Mobility Domain Commands
251
Access Enabled.
Usage This command has no effect if the UNIVERGE WL Controller member is
not configured as part of a Mobility Domain or the current UNIVERGE WL
Controller is not the seed.
Examples The following command clears a Mobility Domain member with the IP
address 192.168.0.1:
Controller# clear mobility-domain member 192.168.0.1
See Also set mobility-domain member on page 251
set mobility-domain member
On the seed UNIVERGE WL Controller, adds a member to the list of Mobility
Domain members. If the current UNIVERGE WL Controller is not configured as
a seed, this command is rejected.
Syntax set mobility-domain member ip-addr [key hex-bytes]
Defaults None.
Access Enabled.
Usage This command must be entered from the seed UNIVERGE WL Controller
.
Examples The following commands add three UNIVERGE WL Controllers with
the IP addresses 192.168.1.8, 192.168.1.9, and 192.168.1.10 as members of a
Mobility Domain whose seed is the current UNIVERGE WL Controller:
PROMPT# set mobility-domain member 192.168.1.8
ip-addr IP address of the Mobility Domain member in dotted
decimal notation.
key hex-bytes Fingerprint of the public key to use for UNIVERGE WL
Controller-UNIVERGE WL Controller security. Specify
the key as 16 hexadecimal bytes. Use a colon between each
byte, as in the following example:
00:11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ff