Specifications

set usergroup
Chapter 9
AAA Commands
239
Syntax set usergroup group-name attr attribute-name value
Defaults None.
Access Enabled.
Usage To change the value of an attribute, enter set usergroup attr with the new
value. To delete an attribute, use clear usergroup attr.
To add a user to a group, user the command set user group.
You can assign attributes to individual users and to user groups. If attributes are
configured for a user and also for the group the user belongs, the attributes
assigned to the individual user take precedence for that user. For example, if the
start-date attribute configured for a user is earlier than the start-date configured for
the user group the user belongs, network access for the user can begin as soon as
the user start-date. The user does not need to wait for the user group start date.
Examples The following command adds the user group cardiology to the local
database and assigns all the group members to VLAN crimson:
PROMPT# set usergroup cardiology attr vlan-name crimson
success: change accepted.
See Also
l clear usergroup on page 198
l clear usergroup attr on page 199
l show aaa on page 240
group-name Name of a group for password users. Specify a name
of up to 32 alphanumeric characters, with no spaces.
The name must begin with an alphabetic character.
attribute-name value Name and value of an attribute you are using to
authorize all users in the group for a particular service
or session characteristic. For a list of authorization
attributes and values that you can assign to users, see
Table 25 on page 223.