Specifications

Access Commands
17
3
Access Commands
Use access commands to control access to the UNIVERGE WL Control System
(CLI). This chapter presents access commands alphabetically. Use the following
table to locate commands in this chapter based on their use.
disable
Changes the CLI session from enabled mode to restricted access.
Syntax disable
Defaults None.
Access Enabled.
Examples The following command restricts access to the CLI for the current
session:
PROMPT# disable
PROMPT>
See Also enable on page 17
enable
Places the CLI session in enabled mode, which provides access to all commands
required for configuring and monitoring the system.
Access Privileges enable on page 17
set enablepass on page 19
disable on page 17
quit on page 18