Specifications

show ntp
Chapter 8
IP Services Commands
170
Examples The following command shows the status and port number for the
Telnet management interface to the UNIVERGE WL Controller:
PROMPT> show ip telnet
Server Status Port
---------------------------------
Enabled 23
Table 22 describes the fields in this display.
See Also
l clear ip telnet on page 101
l set ip https server on page 119
l set ip telnet on page 125
l set ip telnet server on page 126
l show ip https on page 165
show ntp
Displays NTP client information.
Syntax show ntp
Defaults None.
Access All.
Table 22. Output for show ip telnet
Field Description
Server Status State of the HTTPS server:
• Enabled
• Disabled
Port TCP port number on which the UNIVERGE WL
Controller listens for Telnet management traffic.