Specifications

show ip telnet
Chapter 8
IP Services Commands
169
See Also
l clear ip route on page 100
l set interface on page 111
l set ip route on page 120
l show interface on page 161
l show vlan config on page 86
show ip telnet
Displays information about the Telnet management port.
Syntax show ip telnet
Defaults None.
Access All.
Gateway Next-hop router for reaching the route destination.
Note: This field applies only to static routes.
VLAN:Interface Destination VLAN, protocol type, and IP address of
the route. Because direct routes are for local
interfaces, a destination IP address is not listed.
The destination for the IP multicast route is
MULTICAST.
For static routes, the value Down means the
UNIVERGE WL Controller does not have an
interface to the destination next-hop router. To
provide an interface, configure an IP interface that is
in the same IP subnet as the next-hop router. The IP
interface must be on a VLAN with the port attached
to the default router.
Table 21. Output for show ip route
Field Description