Specifications

set timedate
Chapter 8
IP Services Commands
154
set timedate
Sets the time of day and date on the UNIVERGE WL Controller.
Syntax set timedate {date mmm dd yyyy [time hh:mm:ss]}
Defaults None.
Access Enabled.
Usage The day of week is automatically calculated from the day that you set. The
time displayed by the CLI after you type the command might be slightly later than
the time you enter due to the interval between when you press Enter and when the
CLI reads and displays the new time and date.
Configure summertime before you set the time and date. Otherwise, the
summertime adjustment makes the time incorrect, if the date is within the
summertime period.
Examples The following command sets the date to March 13, 2003 and time to
11:11:12:
PROMPT# set timedate date feb 29 2004 time 23:58:00
Time now is: Sun Feb 29 2004, 23:58:02 PST
See Also
l clear summertime on page 105
l clear timezone on page 107
l set summertime on page 151
l set timezone on page 155
l show summertime on page 175
date mmm dd yyyy System date:
• mmm—month.
• dd—day.
• yyyy—year.
time hh:mm:ss System time, in hours, minutes, and seconds.