Specifications

set summertime
Chapter 8
IP Services Commands
152
Defaults If you do not specify a start and end time, the system implements the
time change starting at 2:00 a.m. on the first Sunday in April and ending at 2:00
a.m. on the last Sunday in October, according to the North American standard.
Access Enabled.
Usage You must first set the time zone with the set timezone command for the
offset to work properly without the start and end values.
Configure summertime before you set the time and date. Otherwise, the
summertime adjustment of the time makes the time incorrect, if the date is within
the summertime period.
Examples To enable summertime and set the summertime time zone to PDT
(Pacific Daylight Time), type the following command:
Controller# set summertime PDT
success: change accepted
See Also
l clear summertime on page 105
l clear timezone on page 107
l set timedate on page 154
l set timezone on page 155
l show summertime on page 175
l show timedate on page 176
l show timezone on page 177
hour Hour to start or end the time change—a value between 0
and 23 on the 24-hour clock.
min Minute to start or end the time change—a value between 0
and 59.
end End of the time change period.