Specifications

set snmp usm
Chapter 8
IP Services Commands
146
set snmp usm
Creates a USM user for SNMPv3.
Syntax set snmp usm usm-username
snmp-engine-id {ip ip-addr | local | hex hex-string}
access {read-only | read-notify | notify-only | read-write | notify-read-write}
auth-type {none | md5 | sha}
{auth-pass-phrase string | auth-key hex-string}
encrypt-type {none | des | 3des | aes}
{encrypt-pass-phrase string | encrypt-key hex-string}
Note. This command does not apply to SNMPv1 or SNMPv2c. For these SNMP
versions, use the set snmp community command to configure community
strings.