Specifications

set snmp notify target
Chapter 8
IP Services Commands
137
See Also
l clear snmp notify profile on page 103
l set ip snmp server on page 122
l set snmp community on page 130
l set snmp notify target on page 137
l set snmp protocol on page 143
l set snmp security on page 144
l set snmp usm on page 146
l show snmp notify profile on page 173
set snmp notify target
Configures a notification target for notifications from SNMP.
A notification target is a remote device that the UNIVERGE WL Control System
sends SNMP notifications to. You can configure the UNIVERGE WL Control
System SNMP engine to send confirmed notifications (informs) or unconfirmed
notifications (traps). Some of the command options differ depending on the
SNMP version and the type of notification you specify. You can configure up to
10 notification targets.
SNMPv3 with Informs
To configure a notification target for informs from SNMPv3, use the following
command:
Syntax set snmp notify target target-num ip-addr[:udp-port-number]
usm inform user username
snmp-engine-id {ip | hex hex-string}
[profile profile-name]
[security {unsecured | authenticated | encrypted}]
[retries num]
[timeout num]