Specifications

set ntp

Chapter 8

IP Services Commands

127

set ntp

Enables or disables the NTP client on a UNIVERGE WL Controller.

Syntax

set ntp {enable | disable}

Defaults

The NTP client is disabled by default.

Access

Enabled.

Usage

If NTP is configured on a system whose current time differs from the NTP

server time by more than 10 minutes, convergence of the UNIVERGE WL

Controller time can take many NTP update intervals. It is recommended that you

set the time manually to the NTP server time before enabling NTP to avoid a

significant delay in convergence.

Examples

The following command enables the NTP client:

PROMPT# set ntp enable

success: NTP Client enabled