Specifications

set ip telnet server
Chapter 8
IP Services Commands
126
set ip telnet server
Enables the Telnet server on a UNIVERGE WL Controller.
Syntax set ip telnet server {enable | disable}
Defaults The Telnet server is enabled by default.
Access Enabled.
Usage The maximum number of Telnet sessions supported on a UNIVERGE
WL Controller is eight. If SSH is also enabled, the UNIVERGE WL Controller
can have up to eight Telnet or SSH sessions, in any combination.
Examples The following command disables the Telnet server on a UNIVERGE
WL Controller:
PROMPT# set ip telnet server disable
success: change accepted.
See Also
l clear ip telnet on page 101
l set ip https server on page 119
l set ip telnet on page 125
l show ip https on page 165
l show ip telnet on page 169
Caution! If you disable the Telnet server, Telnet access to the UNIVERGE WL
Controller is also disabled.
enable Enables the Telnet server.
disable Disables the Telnet server.