Specifications

set ip telnet
Chapter 8
IP Services Commands
125
set ip telnet
Changes the TCP port number on which a UNIVERGE WL Controller listens for
Telnet management traffic.
Syntax set ip telnet port-num
Defaults The default Telnet port number is 23.
Access Enabled.
Examples The following command changes the Telnet port number on a
UNIVERGE WL Controller to 5000:
PROMPT# set ip telnet 5000
success: change accepted.
See Also
l clear ip telnet on page 101
l set ip https server on page 119
l set ip telnet server on page 126
l show ip https on page 165
l show ip telnet on page 169
Caution! If you change the Telnet port number from a Telnet session,
UNIVERGE WL Control System immediately ends the session. To open a new
management session, you must Telnet to the UNIVERGE WL Controller with
the new Telnet port number.
port-num TCP port number.