Specifications

clear ntp server
Chapter 8
IP Services Commands
102
clear ntp server
Removes an NTP server from a UNIVERGE WL Controller configuration.
Syntax clear ntp server {ip-addr | all}
Defaults None.
Access Enabled.
Examples The following command removes NTP server 192.168.40.240 from a
UNIVERGE WL Controller configuration:
PROMPT# clear ntp server 192.168.40.240
success: change accepted.
See Also
l clear ntp update-interval on page 102
l set ntp on page 127
l set ntp server on page 128
l set ntp update-interval on page 129
l show ntp on page 170
clear ntp update-interval
Resets the NTP update interval to the default value.
Syntax clear ntp update-interval
Defaults The default NTP update interval is 64 seconds.
Access Enabled.
ip-addr IP address of the server to remove, in dotted decimal
notation.
all Removes all NTP servers from the configuration.