Specifications

38
GOVERNOR SERVICE
Static Adjustment - Governor
With the engine stopped, loosen the screw holding the
governor lever to the governor shaft. Push the governor
lever up to move the carburetor throttle plate(s) to the
wide-open throttle position. Rotate the governor rod
in the same direction. Hold the lever and rod in this
position while tightening the screw (diag. 70).
Speed Controls and Linkage
The TVT series engine offers the adaptability of throttle
cable connection from either side of the engine. Either
cable position must pull against the governor spring
force, to increase the engines speed.
NOTES
Both the upper and lower governor spring connections
must be installed correctly to prevent improper operation
(diags. 71 and 72).
Whenever the carburetor or the governor linkage is
removed or replaced, the engines governed R.P.M.’s
must be checked. Use microfiche card #30 or the
computer parts look-up system to locate the correct
R.P.M. settings for the engine model and specification
you are repairing.
71
72
ROTATE
70
www.mymowerparts.com
For Discount Tecumseh Engine Parts Call 606-678-9623 or 606-561-4983