Description of the vacuum Of Owner’s Manual models HHPL & HHPM www.simplicityvac.com SV-HH_Manual_4.06.
Contents IMPORTANT SAFETY INSTRUCTIONS . ............................................................. Product specifications . ..................................................................................... Description of the air cleaner . ........................................................................... 2 3 4 Operation Air cleaner setup ............................................................................................... 6 Display panel . .....................................
IMPORTANT SAFETY INSTRUCTIONS Product Specifications When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE he manufacturer cannot accept responsibility for damage WARNING: Tcaused when the appliance is not used according to the instructions, or for uses other than those for which it was intended.
Description of the air cleaner Description of the air cleaner Five-stage Cleaning Front Side Air undergoes five separate processes before returning, 1 freshened and cleaned, to the room. Stage 1 Washable Anti-Bacterial Pre-Filter (#7) This reusable filter collects large particles, pollen, pet hair, lint, etc. Stage 2 HEPA Filter (#6) Captures 99.99% of particles and impurities as small as .3 microns.
Operation Operation Note: Follow these instructions for best results. • Place unit at least 7 feet from equipment that emits electric waves such as televisions or radios. • Place unit at least 2 feet from the wall. Display Panel 1 9 6 12 7 10 2 3 • Keep sensors away from drafty areas. 4 5 8 11 3 • Keep curtains away from sensors, as they may interfere with air intake/outlet. • Place unit on a stable surface with plenty of air circulation. 1.
Operation Operation Automatic Plasma on/off The unit is set to default to Automatic Activate PlasmaWave by depressing for 2-3 operation when it is first turned on. The air seconds the Plasma ON/OFF button on the cleaner will automatically sense the amount remote, or the POWER button on the unit. of impurities in the air, and adjust the fan PlasmaWave generates positive and negative speed accordingly. ions.
Operation Operation Odor Sensor Remote Control The odor sensor responds to cigarette Preparation smoke and pet odors, as well as other • Press and slide the back cover of the remote to remove. air contaminants such as insecticides, • Insert batteries as shown. cosmetics, alcohol or aerosol sprays. Low Medium High • Close the back cover. Indoor Odor Volume Battery Use Dust Sensor • The batteries for the remote control The dust sensor detects particles in the air are for initial use only.
Operation Operation POWER button Using the Remote Control indicator light on the unit will show the remaining amount of time. The unit will Proper conditions stop operating when the set amount of • Operate the remote control facing the air time runs out. cleaner. Fan Control • Operate within 20 feet of the air cleaner. Up Use this button to switch from Poor conditions that may impair operation Automatic operation and increase AUTO SLEEP button the fan speed level.
Maintenance and Care Maintenance and Care Cleaning Changing Filter • Clean unit as necessary by wiping with a dry, Warning: Before replacing or cleaning any soft cloth; for stubborn stains, use a warm, damp filters, make sure to remove the power plug cloth. from the wall outlet. • Do not use volatile fluids such as benzene, paint thinner, or scouring powder, as they may damage the unit surface.
Maintenance and Care Maintenance and Care Cleaning filter continued… FILTER CASSETTE • Remove the front panel and filter cassette as described in Changing Filter (page 15). CASSETTE SHORT TABS FILTER TAB • Remove the Pre-Filter by gently pulling one side of the cassette frame outward while lifting the Pre-Filter tab at the same time. When one edge is clear of the frame, the Pre-Filter will slide out for cleaning. • Lightly vacuum the Pre-Filter and wash with water and a mild household detergent.
Maintenance and Care Problem Solving Guide Troubleshooting Cleaning filter continued… Possible Solution Problem • Replace each filter in the cassette frame by inserting one long edge first, then snapping into place by pushing sideways and down at the same time. Make sure both filters are completely inside the The remote control does not work. • Make sure the remote control batteries are inserted correctly. • Replace worn-out batteries. The unit leaves smoke and odors in the air.
Warranty Owner’s Warranty Information keep this for your records… Two Year Limited Warranty What is Covered: This warranty covers any defects in material and workmanship in your new Simplicity Healthy Home air cleaner. How Long Coverage Lasts: Warranty coverage for your Simplicity Healthy Home air cleaner lasts two years.
Notes SV-HH_Manual_4.06.
www.simplicityvac.com ©2006 Tacony Corporation SV-HH_Manual_4.06.
