Specifications

6. Loading Sample Application
Loading Sample Application onto EZR32 with Simplicity Studio
Once your sample application is built, you can load it onto your device using Simplicity Studio. There are several ways to do this. If you
have compiled your application in Simplicity Studio, you will notice some images listed under the Binaries menu item in the Project Ex-
plorer View. You can flash your image to a device by right-clicking on the image you wish to load in the Project Explorer View and
selecting the [Flash to device] option.
Figure 6.1. Flash Selected Image to Device
You can also upload your image to a device through the Adapters View. To do this go to the Adapters View in Simplicity Studio, which
is visible in either the AppBuilder Perspective or in the Network Analyzer Perspective. Right-click on your device of choice, select [Con-
nect] and then [Upload]. Navigate to the .bin or .hex image you wish to upload and click [OK].
Figure 6.2. Uploading .bin or .hex Image
Note: Please make sure that the power switch on your WSTK board is set in the “AEM” position when attempting to flash your device.
Quick Start Guide
Loading Sample Application
silabs.com | Smart. Connected. Energy-friendly. Rev. 0.2 | 26