Specifications

3. RF Evaluation Using Nodetest
Testing the EZR32 Using the "Nodetest" Application
The “nodetest” application provides a Command Line Interface (CLI) to Simplicity Studio for RF Evaluation of a device. In order to load
the nodetest application, do the following:
1. In the Simplicity Studio Perspective, select one of the RF devices you would like to load nodetest onto.
2. With the device selected, select the [Network Analyzer] tile on the right-hand side.
Figure 3.1. Network Analyser Tile
3. The Network Analyzer Perspective opens. In this perspective you will see the Adapters View on the left-hand side of the screen.
4. Rightclick on the device to which you would like to load the nodetest application, and select [Connect] to connect to the device.
5. Right-click on the WSTK board in the Adapter’s menu again and select [Flash / Upload].
Figure 3.2. Flash/Upload
6. Choose from the list of applications the nodetest application that is appropriate for your device and click [OK]. You will notice that
there several nodetest images available depending on your frequency band: 900 covering 915 and 800 covering 868, 490, and
434. Be sure to select the image that supports the radio card on your WSTK board.
Quick Start Guide
RF Evaluation Using Nodetest
silabs.com | Smart. Connected. Energy-friendly. Rev. 0.2 | 11