Specifications

2.3.2 760-A AQUASWITCH MAIN AC POWER
NOTE:
The following procedures are to be used to install the 760-A
Aquaswitch 115 VAC main power source. For the procedures
to install the optional 220 VAC main power source, the user
must rst complete the installation procedures in Section 2.3.3.
Failure to do so could result in damage to equipment and/or
property.
STEP 1 Verify that the facility’s 115 VAC power source is turned
OFF or disconnected.
STEP 2 Following STEPS 2 and 3 in Section 2.2.2, remove the
front panel.
STEP 3 Place the facility’s AC power cord and watertight cable
restraint into the enclosure’s appropriate access hole.
STEP 4 Neatly connect cable wires to the 760-A Control board
TB1 terminal block connectors as shown in Fig. 2-6.
2.3.3 220 VAC CONVERSION
AQUASWITCH
STEP 1 Verify that the facility’s 115 VAC power source is turned
OFF or disconnected.
STEP 2 Locate and remove Power Module jumpers E1 and E2.
(See Fig. 4-1)
STEP 3 Using one of the removed jumpers, insert it into jumper
E3’s connection holes as shown in Fig. 2-7.
760-A AQUASWITCH
STEP 1 Verify that the facility’s 115 VAC power source is turned
OFF or disconnected.
STEP 2 Locate and remove 760-A Control board jumpers E1
and E3. (See Fig. 4-1)
STEP 3 Using one of the removed jumpers, insert it into jumper
E2’s connection holes as shown in Fig. 2-8.
STEP 4 Follow STEPS 2 and 3 in Section 2.3.3 to convert the
Power Module 115/220 VAC jumpers.
6