Operator`s manual

Optional Equipment
Simplicity Australia Page 7s.3 Version 1.0
Proper care,
regular maintenance
and lubrication will
ensure years of
trouble free operation
and product life
Lubrication and Maintenance
Pre Season
Prior to the sowing season the small seeds box drive components
should be checked to ensure all is in good order.
 Check small seeds box drive chain and tensioner rollers for wear
and proper alignment.
 Check all shafts are turning freely
 Grease metering unit bearings
 Grease drive shaft bearings
 Check Zeromax drive oil level following the procedure outlined on
Page 4.6 of the Operators manual
 Check for air leaks as outlined on Page 4.9
Daily
 Visually check drive chain and tensioner rollers
 Grease drive shaft bearings
 Start blower to check for any air leaks from small seeds box
components
After Sowing Maintenance
 After Sowing Maintenance should be carried out at the end of the sowing
season following any procedure outlined on Page 4.3 that would be
applicable to the small seeds box
Care should be
taken when greasing
metering unit shaft
bearings. One shot
of grease every 100
hours is sufficient.
Over greasing and
using air operated
greasing equipment
can damage the
bearing seals and
shorten the bearing
life
IMPORTANT
CAUTION: Do NOT open bin lids while
blower is operating. Release of lids
under pressure will cause unwanted
movement of seed or fertilizer which
could result in injury.
WARNING: Confined Space. Do
not enter any bin unless tractor is
switched off and keys removed.
Always have another person
present when working in the bin