Operator`s manual

Maintenance
Simplicity Australia Page 4.10 Version 1.0
 Check the seal inside the bin lid for
damage. If damaged replace the
seal.
 Check that the seal is positioned so
it will contact the lip around the top
of the bin when the lid is closed.
 When closing the lids check that
the latches close with ‘over centre’
force. This will ensure that the lids
are tight and pressure is applied to
the seal.















 Over centre adjustment is
achieved by adjusting the eye of
the latches in or out until desired
pressure is obtained.
 Further adjustment is available by
tightening the lock nuts on the
hinges.
Swing Away Door
If an air leak is detected at the swing away door seal, stop the
blower, open the door and check the condition of the seal.
Repair and adjust if necessary by following the procedures
outlined below and with consideration to the following:
CAUTION: Do NOT open the swing away doors while
blower is operating. Release of doors under pressure could
result in injury