Operator`s manual

Operation
Simplicity Australia Page 3.3 Version 1.0
Remove flow
through tubes as
shown for volume
unloading and for
unloading coarse
seeds
Filling and Emptying Bins
Emptying
Simplicity Australia Air Seeders are designed so that emptying the bins
is a quick and simple operation.
The method for transferring the product to storage should be
determined prior to emptying the bins and would be dependant on how
much product is left in the bins.
A genuine Simplicity Australia load/unload auger is available for most
Simplicity Air Seeders. If the Air Seeder has an auger fitted refer to
Pages 7.5 – 7.9 for detailed instructions on the auger operation.
Using an auger is the best method of emptying large quantities of
product. If an auger is not fitted another manufacturer’s mobile auger
will need to be used.
 Place the auger hopper under the bin to be
emptied
Open the swing away door
 Start the auger
 Open the clean out door
 Product will now run from the bin through
the metering unit into the auger hopper.
For emptying a small amount a tub or similar could be used to catch the
product.
Do not attempt
to close the
clean out door
while emptying
IMPORTANT
WARNING: Be aware of the equipments
height when working around overhead
power lines. Contact with overhead power
lines will cause serious injury or death.
WARNING: Do NOT open swing away doors while
blower is operating. Release of lids under pressure
could cause injury.
WARNING: Confined Space. Do not enter
any bin unless tractor is switched off and
keys removed. Always have another person
present when working in the bin