Operator`s manual

3500 VRC Operator’s Manual

V5.00.26

October

2006

Revision M

Part No. : AM

3500V/M/SIMV5

Updated : 12/10/2006

Set Up Parallel Swath Guidance

1. Press the front panel “MODE” key to enter parallel swath guidance mode.

2. Drive into the field, check GPS/DGPS coordinates are being received. The canlink can be on or

off hold.

3. Prepare to drive the first swath. Align the vehicle with the direction of the swath but do not

start driving the first swath.

4. Approach the start of the first swath and when it has been reached, press the bottom "POINT

A" softkey. The start co-ordinates have now been stored and "POINT B" will be displayed.

5. Keep driving along the swath and near the end of the swath press the softkey under "POINT

B". The end co-ordinates of the swath have now been stored and "RESET" is displayed.

Indicating that the setup swath has been locked in and guidance to parallel swaths will start

immediately.

“POINT B”

“POINT A”