Operator`s manual

3500 VRC Operator’s Manual

V5.00.26

October

2006

Revision M

Part No. : AM

3500V/M/SIMV5

Updated : 12/10/2006

Changing Product Names

Up to 24 seed and fertiliser names can be created for selection when calibrating bins. Product

names have a maximum length of 6 characters.

Product type can also be set, as either liquid or solid. Setting the product type determines the units

used to display calibration factors, rates and product totals for that product. If for example a

product is given the liquid type then product totals will be displayed in litres and the calibration

factor and rate will be displayed in pulses per litre and litres per hectare respectively.

There are 16 existing common product names, which can also be edited.

1. Press “CAL” to display the calibration menu.

2. Use the arrow keys to highlight “PRODUCT”.

3. Press the “CAL” key. The “PRODUCT NAMES” screen is displayed. See below.

Edit or Create Product Names

1. Highlight “PRODUCT” in the calibration menu. Press the “CAL” key to display “PRODUCT

NAMES” menu.

2. Use “NEXT” softkey at bottom of screen to toggle between first and second page of product

names.

3. Press the left hand side softkeys pointing at the product name until it is highlighted, or select a

blank space to create new product names.

4. Use the left and right arrow keys to move the curser over the character to change.

5. Select one of the three character types “SPACE”, “0-9” or “A-Z” at the bottom of the screen.

6. Use the up and down arrow keys to change each character as required.

7. Repeat 4 – 6 to continue editing.

8. Press the bottom “TYPE” softkey to select solid or liquid for the product.

Tips

?? Holding down either the up or down arrow keys for one second will cause the highlighted

character to scroll through all available letters or numbers.

?? To insert a slash, move the curser to a new location and press the up or down arrow key.