Operator`s manual

3500 VRC Operator’s Manual

V5.00.26

October

2006

Revision M

Part No. : AM

3500V/M/SIMV5

Updated : 12/10/2006

Prime (Liquid Tank Only)

The “PRIME” function is only applicable on DC or hydraulic drive airseeder bins and allows the

operator to pre-start the product metering unit to avoid missed gaps at start off or to test product

delivery to the sowing boots when stationary. To set the “PRIME” time see step 6.

1. Check bins are “READY”.

2. Press the “PRIME” softkey at the bottom of the screen.

3. Product metering will start immediately to the equivalent of 8km/h working speed and

automatic control will take over when ground speed is detected.

4. If no ground speed is detected within the prime time (5-60 seconds), product metering will

stop.

Note

‘Prime’ can be activated using the pod buttons when stationary. Press the green button for 2

seconds to start. Press the red button to stop.