Operator`s manual

3500 VRC Operator’s Manual
6
V5.00.26
October
2006
Revision M
Part No. : AM
-
3500V/M/SIMV5
Updated : 12/10/2006
3500VRC System Overview
The 3500VRC uses the A-3505/HC pod to control and receive information from sensors and motors. It is a four channel
controller with two other outputs for on/off control.
Each of the four channels can control a DC Motor, Hydraulic motor, linear actuator or liquid ball valve each. The two
additional outputs can control master valves used in liquid tanks.
BATTERY CONNECTION
Do not connect battery power until installation is complete.
The POWER CABLE must be connected DIRECT to 12 volt DC vehicle battery terminals.
DO NOT connect monitor to auxiliary power point on tractor or join monitor power cable together
with Clutch Power Cable except at Battery Terminals.
USE cable ties supplied to secure power cable away from risk of damage.
Connection to battery terminals must be clean and tight.
WARNING -Disconnect Monitors from battery connection if arc welding on machinery.
CONNECTION
DETAIL
ONE 12 VOLT BATTERY TWO 6 VOLT BATTERIES TWO 12 VOLT BATTERIES
TYPICAL BATTER
Y
RED BLACK RED BLACK RED BLACK
POS
NEG
POS
POS
NEG
NEG
POS 24V
POS 12V
NEG
NEG
VEHICLE
GROUND
24V Tractors
12V Tractors