Operator`s manual

3500 VRC Operator’s Manual

V5.00.26

October

2006

Revision M

Part No. : AM

3500V/M/SIMV5

Updated : 12/10/2006

11.2 Flexi Steer calibration

When you purchase the optional steering pod the 3500 VGS can steer your machine in parallel.

To set up and calibrate the Flexi Steer just follow the following simple steps.

1. Select the AUTOSTEER menu and press CAL. The following screen will appear.

2. the CMD value must be “ON”

3. Leave the MINLOOK and MAXLOOK at the defaults of 2.0 and 2.5 respectively.

4. Enter in the measurements for the TOSAXLE (Antenna to steer axle) and the TODAXLE

(Antenna to drive axle)

5. Enter in the antenna height in the HEIGHT field.

6. Move to a level surface and press the GRYO soft key.

7. Press the TILT soft key.

8. Hold down the FRONT/SIDE soft key. The value will change from FRONT to BACK or visa

versa. Depending on where the steering pod has been mounted choose the correct setting.

This is important as the pod houses the GYRO’s. The correct setup is needed for GYRO’s to

supply the correct information to the system.

9. Hold down the HEIGHT soft key until STEERING changes to SETOFFSET