Operator`s manual

3500 VRC Operator’s Manual

V5.00.26

October

2006

Revision M

Part No. : AM

3500V/M/SIMV5

Updated : 12/10/2006

Step 9

9.1 - Data Card & Logging Interval

Rates applied and GPS co-ordinates can be logged onto an MMC card. The data card is also used

to upload new software onto the canlink platform. To log data and upload software the data card

must be enabled. For logging, a log interval must also be set and GPS data being received.

Data cards must be the MMC type with 16,32, 64 or 128Mb capacities. The storage capacity of

data cards will be detected automatically once enabled.

1. Press “CAL” to display the calibration menu.

2. Use the arrow keys to highlight “DATA CARD”.

3. Press the “CAL” key. The “DATA CARD” screen is displayed. See below.

9.1.1 - Enable Data Card

1. Press the softkey pointing at “DATA CARD”.

2. Use the up and down arrow keys to change “DISABLED” to “ENABLED”. The data card is ready

for use.