Operator`s manual

3500 VRC Operator’s Manual

V5.00.26

October

2006

Revision M

Part No. : AM

3500V/M/SIMV5

Updated : 12/10/2006

5.9 – Bin Liquid Pressure Alarm (where fitted)

Warns the operator when the liquid pressure in the liquid manifold is outside the low and high set

points. Four liquid pressure alarms are available in the event of liquid control being used on all bins.

Enabling this alarm displays a live readout of liquid manifold pressure.

5.9.1– Enable

1. For a single liquid pressure, press and hold for 3 seconds the softkey pointing at “LIQUID 4”.

2. “DISABLED” will change to “ENABLED”. If LIQUID 4 is operating live pressure will be

displayed.

5.9.2- Set High and Low Points

3. Press the softkey pointing at “LIQUID 4” until the liquid 4 low alarm value is highlighted.

4. Use the arrows keys to enter the liquid 4 low alarm point. Refer to manufacturer

recommended settings.

5. Press the softkey pointing at “LIQUID 4” until the liquid 4 high alarm value is highlighted.

6. Use the arrows keys to enter the liquid 4 high alarm point setting. Refer to manufacturer

recommended settings.