Operator`s manual

3500 VRC Operator’s Manual
20
V5.00.26
October
2006
Revision M
Part No. : AM
-
3500V/M/SIMV5
Updated : 12/10/2006
Liquid
1. Check “PRODUCT CALIBRATION” screen is displayed. See below.
1. Press the softkey pointing at “CAL SPEED”. Use the arrow keys to enter the airseeder
manufacturer’s recommended metering speed for the product being calibrated.
1 = 10% Slowest Speed
5 = 50% Half Speed (Use if unknown)
10 = 100% Maximum Speed
PRODUCT CALIBRATION
EXIT SETPRV FLUSH READY UPDATE BACK
CAL SPEED
TEST PULSES
TEST WEIGHT
PULSE/LT
BIN 1
4
0.00
600
0.00LT
Press to highlight
“CAL SPEED”
Press to highlight
“TEST WEIGHT”
value
Press to
calculate
“PULSE/KG”
factor
Press to
FLUSH
CAL
Use arrow keys to
enter: cal speed,
test pulse and
test weight
values.
Press to highlight
“TEST PULSES”
value
Press to start
metering
product for
calibration
Press to
SETPRV
3. Press the softkey pointing at “TEST PULSES”. Use the arrow keys to enter the recommended
number of pulses to obtain a sizeable quantity of product for measuring.
Example “TEST PULSES 600”.
4. Press the bottom “READY” softkey.
5. Be ready at the nozzles to catch product.
6. Press green button on the pod to prime flow control valve, then press red button to stop flow.
Empty bucket and reposition under nozzles.
7. Press green button to start product calibration run (red button may be used to stop and reset
the batch in case of a false start).
8. The flow control valve will stop after completing the test pulse quantity. If the original batch is
too small, repeat step 7 after completion of the first batch to double the quantity.
Note
The displayed “TEST PULSES” count may be slightly higher than the original set amount. Due to
normal motor overrun after reaching the test pulse quantity.