Operator`s manual

3500 VRC Operator’s Manual
103
V5.00.26
October
2006
Revision M
Part No. : AM
-
3500V/M/SIMV5
Updated : 12/10/2006
Nudge
Compensates for errors in GPS position that may occur when guidance was stopped and resumed
after a long period.
When the nudge function would be used
A swath is left half finished and on the next day the operator resumes work. The operator finds the
same unfinished swath and follows the same tyre tracks observing a cross track error.
4. Press “CAL” to display the calibration menu.
5. Use the arrow keys to highlight “GUIDANCE”.
6. Press the “CAL” key. The “GUIDANCE SETUP” menu is displayed. See below.
To Correct Cross Track Error
Press and hold the “NUDGE” softkey down for 3 seconds. The “NUDGE” icon will then disappear
and the canlink will compensate for the cross track error. See the screen below.
Operating Flexi Steer
To operate the steering option mark out you field as described in Operation. After you have your
parallel lines marked out, pressing the left lower soft key below the navigation line will ENGAGE
Flexi Steer. The same key will also DISENGAGE Flexi Steer. Turning the wheel will disengage Flexi
Steer.