Operator`s manual

3500 VRC Operator’s Manual

V5.00.26

October

2006

Revision M

Part No. : AM

3500V/M/SIMV5

Updated : 12/10/2006

Step 2

2 - Drive Setup

Drives for each bin must be selected and calibrated (setup) before operation.

2.1 – Drives Available

Bins 1, 2 & 3 Bin 4 Output 5 & 6 Description

DC MOTOR DC MOTOR 12 volt DC motor

GEAR BOX GEAR BOX Linear actuator over gear box (ground

drive)

HYD PROP 2 HYD PROP 2 Hydraulic proportional valve with

dither

HYD PROP/XPRO

Hydraulic proportional valve

HYD MFC HYD MFC Motorized flow control valve

HYD DANFOSS HYD DANFOSS Hydraulic PVG32 Danfoss valve

(proportional valve)

HYD DANFOSS L

HYD DANFOSS L Hydraulic PVG32 Danfoss valve

(proportional valve) operating a pump

LIQUID LIQUID Control valve and flow sensor

MONITOR MONITOR Solenoid activated clutch for bin –

monitors only – no control.

CLUTCHSOL CLUTCHSOL Solenoid activated clutch on ‘run/hold’

CLUTCHLIN Linear actuated clutch on ‘run/hold’

Section Valve 2 wire Motorised 2 wire section valves

Section Valve 3 wire Motorised 3 wire or solenoid section

valves

Note

An extra control option is available for bin 4: “CLUTCHLIN” (linear actuator clutch).

2.2 – Setting Up Drives

To calibrate a bin drive, the bin must be enabled and a drive selected. Follow the procedures below

“2.2.1 - Enable Bin Drive” and “2.2.2 - Select Bin Drive” for each bin.