User Manual
Table Of Contents
13
Cutting Height Adjustment (Slot Type)
The cutting height adjust pedal adjusts the mower cutting
height. SeeSpecificationsfor cutting height adjustment
range.
To adjust cutting height:
1. Fully depress the cutting height adjust pedal (A,
Figure14).
2. Move the cutting height adjust lever (B, Figure14) into
the desired cutting heightslot (C).
3. Slowly release the cutting height adjust pedal.
14
Cargo Bed (select models)
The cargo bed is designed to carry up to 50 lbs (22,7 kg).
Slots in the rear of the bed will accommodate a 2 x 4 or 2 x 6
to help secure loads during transport.
WARNING
Amputation Hazard
Rotating blades cut off arms and legs. Do not carry riders
(especially children) even with the blades off. They may fall
off or return for another ride when you are not expecting it.
WARNING
Loss of Control and Roll-Over Hazard
Operating with loads in the cargo bed greater than 50 lbs
can be hazardous and cause loss of control and roll-overs.
The cargo bed can be raised to access the engine
compartment without removing it.
To raise the cargo bed
1. Raise the seat (A, Figure15).
2. Pull up firmly on the rear of the bed (B, Figure15).
3. When lowering the bed, press down firmly to secure the
rear of the bed in place with the locking clips (D).
To remove the cargo bed
1. Remove the pins (C, Figure15) securing the front of the
bed to the rider frame.
2. Pull up firmly on the rear of the bed to release the locking
clips (D, Figure15).
3. Lift and remove the cargo bed from the rider.
CAUTION
To avoid injury, assistance is required when removing or
installing the cargo bed.
To install the cargo bed
1. Position the bed over the engine compartment, aligning
the holes in the front of the bed with the holes in the
frame brackets.
2. Install the pins (C, Figure15) into the holes.
3. Lower the rear of the bed, pressing down firmly to secure
with the locking clips (D, Figure15).
CAUTION
To avoid injury, assistance is required when removing or
installing the cargo bed.
Not for
Reproduction