Specifications

44
ScaleXYZ = {0.001, 0.001, 0.001};
};
When you reload the model, the picture you get should be similar to what you see below. The dumbbell is
visible now and has the right size, but it is sitting at the center of gravity of the lower arm rather than at the
hand, and it is not oriented correctly.
The fact is that, when you attach something to a segment, it is positioned at the segment's origin which is
usually the same as the center of mass. However, you can also attach stuff to points, so moving the
dumbbell to the hand is simply a question of moving the reference to it from the ForeArm segment to the
PalmNode that we defined previously. Block the entire AnyDrawSTL folder with the mouse and cut it out.
Then re-insert it under the PalmNode like this:
AnyRefNode PalmNode = {
sRel = {0.27,0,0};
AnyDrawSTL DrwSTL = {
FileName = "dumbbell.stl";
ScaleXYZ = {0.001, 0.001, 0.001};
};
};
AnyDrawSeg DrwSeg = {};
}; // ForeArm
On reload, this produces a new picture with the dumbbell attached at the right location, but it is still not
oriented correctly.