Specifications

6.4.3 Driver Encoder Bypassing
If it has been determined that the output of an encoder PAL on
the Driver Encoder is incorrect, it is possible to manually pro-
gram the input to the Driver.
a. With the transmitter turned OFF, remove the gold jumper
plug that is connected to the inverter input at JP2 or JP3.
1. If the PAL output should be logic low (Driver off) but
is not, connect the input to the inverter to ground.
2. If the PAL output should be logic high (Driver on) but
is not, connect the input to the relay driver to +5Vdc at
JP3-1 or JP3-16.
6A-4 888-2339-002
WARNING: Disconnect primary power prior to servicing.