Specifications

3-8 888-2500-001 5/2/2013
WARNING: Disconnect primary power prior to servicing.
DAX-1/DAX-3
Section 3 Operation
• Frequency: RF Carrier frequency
• EXC HW: Exciter/Controller board hardware version
• EXTIO HW: External I/O board hardware version
• SW REV: Control software version
The following steps will take you to the above listed statuses:
STEP 1 Pressing the INFO button takes you to submenu screen
STEP 2 Select STATUS SUBMENU using the UP or DOWN buttons
STEP 3 Press ENTER to bring up below screen
Figure 3-8 Status Screen
3.3.4 Digital Mode Selection
Use the following procedure to navigate to the Setup screen to edit your IBOC mode
selection:
STEP 1 Pressing the INFO button takes you to submenu screen
STEP 2 Select SETUP SUBMENU using the UP or DOWN buttons
STEP 3 Press ENTER to bring up below screen
Figure 3-9 Setup Screen
STEP 4 Use the UP and DOWN to select DIGITAL MODE
STEP 5 Once selected, use the ENTER button to toggle the Digital mode on or
off according to your system