Specifications

3-6 888-2500-001 5/2/2013
WARNING: Disconnect primary power prior to servicing.
DAX-1/DAX-3
Section 3 Operation
NOTE:
This procedure requires 2 separate sets of steps (Power Level Range: Steps 1 - 8,
and Actual RF Power Output: Steps 9 - 13) for each power level desired.
STEP 1 Press the INFO button to take you to below screen
Figure 3-5 INFO Screen
STEP 2 Select LEVEL SUBMENU using the UP or DOWN buttons
STEP 3 Press ENTER to bring up below screen
Figure 3-6 Level Range Screen
STEP 4 Select desired Power Level Range value using the UP or DOWN buttons
STEP 5 Press ENTER to select
STEP 6 Adjust range using the UP or DOWN buttons
STEP 7 Press ENTER to accept range value for that power level
STEP 8 Repeat STEP 4 through STEP 7 for remaining Power Levels
Next time that power level is active the DAX will operate within that range.
Once the Power Level Ranges have been set for the Power Levels 1 - 5, continue with
the procedure below to set the actual RF power output:
STEP 9 Press the POWER button to return to main screen
STEP 10 Select the desired Power Level 1 - 5 (see "3.3.3.2 Selecting Power
Levels 1 - 5" on page 3-5)
STEP 11 Raise or lower the RF power by using the RAISE or LOWER buttons on
the front panel