Specifications
5/2/13 888-2500-001 2-9
WARNING: Disconnect primary power prior to servicing.
Section 2 Installation
DAX-1/DAX-3
Figure 2-3
E10 Safety Ground Block
(Shown with Fan Panel)
2.3.4 Power Supply Connections
Power supply connections are performed in two steps: Main Transformer connections,
followed by Transmitter AC Connections. These procedures follow below.
!
CAUTION:
WHEN NECESSARY REFER TO THE DRAWING TITLED "WIRING DIAGRAM"
FOR ELECTRICAL CONNECTIONS. SCHEMATIC DRAWING INFORMATION
WILL ALWAYS SUPERCEDE INFORMATION PROVIDED IN THIS TECHNICAL
MANUAL.
2.3.4.1 Main Transformer Connections
The NEMA transformer enclosure has two 1ΒΌ" holes for cable entry and exit.
E10 Safety
Bottom AC
Entry
Ground Block
Power Supply
Chassis Opening
PS Ground
Wire #98
("square slot")
B+ Supply
Connector J1/P1