Specifications

5/2/13 888-2500-0011 2-1
WARNING: Disconnect primary power prior to servicing.
DAX-1/DAX-3
Section 2
Installation
2
2.1 Introduction
This section details the procedures to receive, install, and prepare the transmitter for
use, as well as initial turn-on steps.
2.2 Unpacking & Returns and Exchanges
Refer to the second page of this manual for instructions on unpacking, inspecting, and
procedures in the event of any damages from shipment or omissions.
NOTE:
Retain all packaging materials in the event the transmitter would require factory
servicing.
2.2.1 Inspection
Prior to performing the installation of the DAX transmitter, it should be thoroughly
inspected for any connections which may have loosened during shipment. Also check
that all ribbon cables are properly locked into their respective printed circuit board
connectors, and that the PA modules are securely inserted. Check for debris or any other
loose hardware.
2.2.2 Weight and Dimensions
The DAX-1 weighs approximately 130 pounds/45 kg; DAX-1R: 140 pounds/63 kg;
and the DAX-3 weighs approximately 160 pounds/73 kg; and each has been designed
for rapid installation. It can be shipped in an optional rack or mounted in a customer
supplied rack, or simply installed on a small pedestal or table.
NOTE:
It is not recommended to install the basic DAX-1/DAX-3 cabinet on the floor.