Specifications

6-26 888-2500-001 5/2/2013
WARNING: Disconnect primary power prior to servicing.
DAX-1/DAX-3
Section 6 Troubleshooting
STEP 2 Insert PA module key card in slot BELOW module to be removed - PA
Module LED will turn amber
STEP 3 Unscrew right and left thumbscrews
STEP 4 Remove module
STEP 5 Install PA module verified in STEP 1 and tighten thumbscrews
STEP 6 Remove PA module key card
NOTE:
PA module may take up to 45 seconds before soft start is complete and module
turns ON.
6.3.5.2 Mod Replacement: Spare PA Dummy Mod
DAX-1R and DAX-3: For long-term removal of a single PA module (to avoid the
transmitter being faulted off after 5 minutes), the supplied ’dummy’ module will need
to be inserted in place of the removed PA:
NOTE:
Once the key card is inserted a timer starts, allowing 5 minutes of DAX opera-
tion. After 5 minutes it will be faulted OFF if a module is not reinserted and the
key card removed.
STEP 1 Insert provided PA module key card in slot BELOW module to be
removed - PA Module LED will turn amber
STEP 2 Unscrew right and left thumbscrews
STEP 3 Remove module
STEP 4 Install Dummy Module and tighten thumbscrews
STEP 5 Remove PA module key card