Specifications

3. ASSEMBLY WHEATHEART - SELF-PROPELLED AUGER KIT
3.6. OVER-CENTER DRIVE ASSEMBLY—SQUARE AXLES WHEATHEART & COMPETITOR MODELS
20 IM3 R2
3.6. OVER-CENTER DRIVE ASSEMBLY—SQUARE AXLES
1. Once the wheel is bolted to the hub,
the over-center drive assembly can be
installed.
2. Position the axle cap of the over-center
drive assembly squarely on the axle
tube as shown in Figure 3.6.
3. With the pinion gear flush with the ring
gear (Figure 3.6), weld the axle cap to
the axle tube.
Figure 3.6 Over-Center Assembly
Positioning
Figure 3.7 Square Axle over-Center for Competitor Models