Instructions / Assembly

VANITY TOP INSTALLATION
Step 1: Prepare vanity cabinet
• Remove the black gasket between the top and vanity base
• Clean top of cabinet base of debris with a cloth
• Clean floor beneath where vanity will sit and ensure floor is level
• Level vanity cabinet, side-to-side, front to back and diagonally
• Secure vanity cabinet to the wall
• Trial fit vanity top on vanity cabinet to ensure correct size, fit and it is level
• Natural stone is heavy and requires adequate support
Step 2: Install faucet
• While supporting the vanity top carefully, install the faucet set according to
the manufacturer’s instructions
Step 3: Install the vanity top
• Apply a ¼ inch continuous bead of Construction Adhesive or Silicone evenly
along the top of the vanity cabinet
• Gently place the vanity top on the cabinet. This may require two people
• Vanity top must be flush with the back of the cabinet. Standard size tops are
designed with a 1/2-inch overlap on each side of the cabinet except the back
of the cabinet
• Ensure vanity top is correctly positioned before Construction Adhesive or
Silicone dries or becomes permanent (follow adhesive manufacturer’s
instructions)
• Have a soft cloth ready to wipe off any excess sealant should it compress
over the edge and onto the finished sides and allow it to dry according to
adhesive manufacturer’s instructions (24 hours recommended)
BEFORE YOU BEGIN PLEASE READ THESE SAFETY PRECAUTIONS
Consult professional help if you are not familiar with installing bathroom
cabinetry and working with associated plumbing hardware and tools. Installing a
vanity cabinet and vanity top will require more than one person.
We recommend the water lines and drain be roughed in prior to installing the
unit. The plumbing and vanity should be installed by an experienced plumber.