Specification

AXCWAYN-M Wayland Bentwood Dining Chair
P a g e
4
|
9
III. Construction/Specifications for wood part:
- Before mass production, product needs to pass all related tests – conform to US Consumer
Product Safety Commission - at Approved Labs.
- All wood must be kiln dry before production and maintained at a humidity level between
8-12% during the manufacturing process.
- The variance of moisture between 2 lamellas cannot be over 2%.
- Width of lamination: should be between 40-80mm.The lamination should have the same width
on a board.
- All products must be free from physical defects such as poor finish, patchy areas, contamination,
pin holes or pitting.
- Dent, chipped mark, nick… are not allowed.
Finish / Color:
- Back and seat veneer: Natural
- Legs: Natural
IV. Hardware:
- All coatings on metal parts and hardware must comply to CPSIA regulation:
 US Code of Federal Regulations Title 16 CFR 1303 for total Lead content in surface coating.
 US Consumer Product Safety Improvement Act 2008 Title I Section 101 for total Lead
content in surface coating.
- Country of origin: China
- Manufactured by:

Anji Shuntai Hardware co.ltd
- All hardware must be resistant to corrosion: Withstand 24 hours in 1% salt spray test.
V. Packaging:
Packaging must pass ISTA 3A testing by Approved Labs.
A. Hardware package:
Each type of hardware should be packed separately in a zip-bag;
Hardware Red Strings- used to identify the hardware inside the box –must be attached to the
hardware bag at one end, and the other end must be attached to the outside of the box.