Specification

AXCMALW-G Malden Bentwood Dining Chair
P a g e
4
|
9
III. Construction/Specifications for wood part:
- Before mass production, product needs to pass all related tests – conform to US Consumer
Product Safety Commission - at Approved Labs.
- All wood must be kiln dry before production and maintained at a humidity level between
8-12% during the manufacturing process.
- The variance of moisture between 2 lamellas cannot be over 2%.
- Width of lamination: should be between 40-80mm.The lamination should have the same width
on a board.
- All products must be free from physical defects such as poor finish, patchy areas, contamination,
pin holes or pitting.
- Dent, chipped mark, nick… are not allowed.
Finish / Color:
- Back and seat veneer: Natural
- Legs: Natural
IV. Hardware:
- All coatings on metal parts and hardware must comply to CPSIA regulation:
 US Code of Federal Regulations Title 16 CFR 1303 for total Lead content in surface coating.
 US Consumer Product Safety Improvement Act 2008 Title I Section 101 for total Lead
content in surface coating.
- Country of origin: China
- Manufactured by:
 Anji Shuntai Hardware co.ltd
- All hardware must be resistant to corrosion: Withstand 24 hours in 1% salt spray test.